The Colossus platform in Star Wars Resistance may be filled with hotshot pilots and brilliant mechanics, but there’s one crew member who goes largely unnoticed and unappreciated -- until now!

Opeepit, the humble Frigosian maintenance worker, is definitely keeping an eye on Kaz. And if you need someone to keep a watchful eye on unruly trick-or-treaters, you can make a pumpkin that looks just like the hardworking hero to make sure things don’t get too out of hand this Halloween.

Opeepit polishes a floor in front of Kaz and BB-8, in a GIF.

A pumpkin made to look like Opeepit, a maintenance worker in Star Wars Resistance.

What You’ll Need*

Printed Frigosian pumpkin template
Medium orange craft pumpkin
Black glitter craft foam (adhesive backing)
Plain black craft foam
Black tape
Purple plastic Easter eggs
Gray acrylic paint
Black permanent marker
Battery-powered LED light
Pumpkin carving knife
Clear glue
Scissors
Craft knife
Pencil
Chalk
Paint brush

*The activities in this article should only be done with adult supervision.

Get Started!

Step 1: Paint the stem of the craft pumpkin with the acrylic gray paint. Let dry completely.

Step 2: Separate the top and bottoms of the Easter eggs and discard the tops. Trace the bottom of one egg with the chalk on the middle of the pumpkin, making two circles for Opeepit’s eyes about two inches apart. Cut out the circles, and one small circle in the bottom of the pumpkin (for adding and removing the LED light) with the pumpkin carving knife.

A Resistance pumpkin craft, step 1.

Step 3: Print and cut out the shapes on the provided template. Trace the L and R eyes, and the larger shape below them, on the backing of the black glitter craft foam. Cut out the shapes.

Step 4: Cut three strips of the plain black craft foam, about a quarter of an inch wide and one inch long. Glue them in the middle of the nose glitter foam shape and let dry.

A Resistance pumpkin craft, step 2.

Step 5: Next, use the craft knife to cut small openings in the middle of the L and R eye craft foam shapes. Make sure the cut-out shapes are small enough to be hidden by the Easter eggs.

Step 6: Cut several pieces of black tape. Place two between the eyes, and then make a “strap” for Opeepit's goggles going all the way around the pumpkin. (Smaller pieces of tape are easier to work with, but one long piece will also do the job.)

A Resistance pumpkin craft, step 3.

Step 7: Glue the Easter eggs to the L and R eye shapes and let dry completely.

Step 8: Trace and cut out the two buckle shapes on the plain craft foam. Use the craft knife to cut two small rectangles out of each.

A Resistance pumpkin craft, step 4.

Step 9: It’s time to assemble Opeepit! Remove the adhesive backing from the foam pieces and stick the eyes and nose to the pumpkin, completely covering the two circles you cut in the pumpkin previously. Glue the two buckle pieces on either side of the eyes. Let the glue dry.

A Resistance pumpkin craft, step 5.

Step 10: Finally, use the black permanent marker to draw fur shapes all around the pumpkin. (Did you know Frigosians are actually quite fuzzy?) Your Star Wars Resistance pumpkin is complete.

Slide the LED light into the pumpkin and in the dark the goggles will glower at anyone who dares make a mess!

Kelly Knox is a freelance writer who loves creating Star Wars crafts with her daughter. Follow her on Twitter at @kelly_knox.

ALL OF YOUR STAR WARS FAVORITES NOW STREAMING ON DISNEY+

Tagged: Opeepit

Keep It Clean This Halloween With This Star Wars Resistance Pumpkin